Filter Test Cases

1. To filter the test case listing on the Test Library page (In a Test Suite), you can click on the Add Filter dropdown list shown below:

Open

2. The following options will appear:

Open

3. Select the the filter you would like to apply on the Test Library listing and then provide the value for that type of filter and click somewhere else or use Tab on your keyboard. The Test Library listing will get filtered down based on the filter selection. An example of an applied filter is shown below:

4. To add another filter in addition to the existing one, click on Add Filter dropdown list again and perform the same steps.

5. To remove the effect of only one filter, click the x right next to the filter such as the one shown below. To remove all filters together, you can click the Reset filters link.

6- In order to find the path where the test case was found, click on the checkbox next to the test case and click View Suite icon.

12- The path will be displayed starting from Home as highlighted below.

Steps Search

1. If you need to search for a particular command along with any other artifacts, click Steps Search icon in the toolbar:

2. Select the filter for the element you would like to search for. For example, Command.

3. Select the command from the dropdown list and it will automatically display all results

4. For this example, we have selected "Compare" as a search parameter. The screen below shows the Type of object where the command "Compare" was found (It was only used in test cases here), the title of the object, the occurrence (in which particular step) and the path of this object.