Filter DB Connections

1. To filter the DB connections listing on the DB Connections page, click on the Add Filter dropdown list shown below:

Open

2. The following options will appear.

Open

3. Select the the filter you would like to apply on the DB Connections listing and then provide the value for that type of filter and click somewhere else or use Tab on your keyboard. The DB Connections listing will get filtered down based on the filter selection. An example of an applied filter is shown below:

4. To add another filter in addition to the existing one, click on Add Filter dropdown list again and perform the same steps.

5. To remove the effect of only one filter, click the x right next to the filter such as the one shown below. To remove all filters together, you can click the Reset filters link.