Filter Test Library

1. To filter the test library listing on the Test Library page, click on the Add Filter dropdown list shown below:

2. The following options will appear:

3. Select the the filter you would like to apply on the test library listing and then provide the value for that type of filter and click somewhere else or use Tab on your keyboard. The test library listing will get filtered down based on the filter selection. An example of an applied filter is shown below:

4. To add another filter in addition to the existing one, click on Add Filter dropdown list again and perform the same steps.

5. To remove the effect of only one filter, click the x right next to the filter such as the one shown below. To remove all filters together, you can click the Reset filters icon.

Steps Search

1. If you need to search for a particular command along with any other artifacts, click Step Search which can be found after going to a Test Library > Add Filter in classic filters:

2. Alternatively, you can click on the icon highlighted below in the new filters:

3. Provide your search criteria and click on Search. For this example, we have used command "Compare" as a search parameter. The screen below shows the Type of object where the command "Compare" was found (It was only used in test cases here), the title of the object, the occurrence (in which particular step) and the path of this object. You can also use wildcards ( * ) and partial text search for all the fields listed below.