1. To filter the load set listing on the Load Sets page, click on the Add Filter dropdown list shown below:
...
2. The following options will appear.
...
3. Select the the filter you would like to apply on the load set listing and then provide the value for that type of filter and click somewhere else or use Tab on your keyboard. The Load Set listing will get filtered down based on the filter selection. An example of an applied filter is shown below:
...
4. To add another filter in addition to the existing one, click on Add Filter dropdown list again and perform the same steps.
5. To remove the effect of only one filter, click the x right next to the filter such as the one shown below. To remove all filters together, you can click the Reset filters iconthe Reset filters link.
...
| Info |
|---|
...
TipIn case you entered extra spaces in the search text, filters will automatically remove them. |
| Info |
|---|
...
TipMatch Case checkbox is available next to the filter. If not used, search will be case insensitive. |
| Info |
|---|
...
TipTest plan ID and Test plan execution ID are added to the Load Sets page. Comma-separated load set ID’s can be used to search for multiple load sets |