1. To filter the execution set listing on the Execution Sets page, click on the Add Filter dropdown list shown below:
2. The following options will appear.
3. Select the the filter you would like to apply on the execution set listing and then provide the value for that type of filter and click somewhere else or use Tab on your keyboard. The execution set listing will get filtered down based on the filter selection. An example of an applied filter is shown below:
4. To add another filter in addition to the existing one, click on Add Filter dropdown list again and perform the same steps.
5. To remove the effect of only one filter, click the x right next to the filter such as the one shown below. To remove all filters together, you can click the Reset filters icon.
6. If you would like to use the classic filters, click on the icon shown below:
7. To filter the
...
execution set listing on the Execution Sets page using classic filter, click on the Add Filter icon shown below:
8. After clicking on the Add Filter link, the following popup window will appear:
...